HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 34)

Scripting mode 34
;Configure Banner Time Out Value:
Banner Message Timeout = <Integer (0 to 14)> ; current = 3
;Configure Link Speed:
Link Speed = AutoNeg ; Read Only
;Configure Pre-Boot Wake On LAN:
Pre-boot Wake On LAN = < Enabled | Disabled > ; Current = Disabled
;Configure VLAN:
VLAN Mode = < Enabled | Disabled > ; Current = Disabled
;Configure VLAN ID:
VLAN ID = <Integer (0 to 1023)> ; current = 0
;Select Number of Boot Retries:
Boot Retry Count = <Integer (0 to 7)> ; current = 0
[Section iSCSI Boot Main Menu]
[General Parameters]
;Acquire TCP/IP Configuration via Stateful or Stateless Autoconfiguration:
IP Autoconfiguration = < Enabled | Disabled > ; Current = Enabled
;Acquire iSCSI Parameters via DHCP:
iSCSI Parameters via DHCP = < Enabled | Disabled > ; Current = Enabled
;Enable/Disable CHAP Authentication:
CHAP Authentication = < Enabled | Disabled > ; Current = Disabled
;Enable/Disable Booting to iSCSI Target After Logon:
Boot to iSCSI Target = < Disabled | Enabled | One Time Disabled > ;
Current
= Enabled
;Configure DHCP Vendor ID:
DHCP Vendor ID = < String (0 to 32 Chars) > ; current = BRCM ISAN
;Configure Link Up Delay Time in Seconds:
Link Up Delay Time = <Integer (0 to 255)> ; current = 0
;Enable/Disable TCP Timestamp:
Use TCP Timestamp = < Enabled | Disabled > ; Current = Disabled
;Enable/Disable Target Appears as First Hard Drive in the System:
Target as First HDD = < Enabled | Disabled > ; Current = Disabled
;Configure Number of Retries in 2s Interval When LUN is Busy:
LUN Busy Retry Count = <Integer (0 to 60)> ; current = 0
;IP Version Support:
IP Version = < IPv4 | IPv6 > ; Current = IPv6
;Enable HBA Boot Mode:
HBA Boot Mode = < Enabled | Disabled > ; Current = Disabled
[Initiator Parameters]