HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 56)

56 C ONFIGURING THE HP EFS WAN A CCELERATOR
4. Use the controls to complete the configuration, as described in the following table.
Control Description
IP Address Obtain IP address automatically. Specify this option to obtain the IP address from a
DHCP server.
IMPORTANT: The primary and in-path interfaces can share the same subnet. The
primary and auxiliary interfaces cannot share the same network subnet.
Specify IP Address Manually. Specify this option if you do not use a DHCP server to set
the IP address. Specify the following settings:
• IP Address. Specify an IP address. This IP address is the in-path main interface.
• Subnet Mask. Specify the subnet mask.
• In-Path Gateway IP. Specify the IP address for the in-path gateway. If you have a
router (or a Layer-3 switch) on the LAN side of your network, specify this device as the
in-path gateway.
IMPORTANT: If there is a routed network on the LAN-side of the in-path appliance, the
router that is the default gateway for the appliance must not have the Access Control List
(ACL) configured to drop packets from the remote hosts as its source. The in-path
appliance uses IP masquerading to appear as the remote server.