Backup path, Disk pair, Primary path – HP Integrity NonStop J-Series User Manual
Page 118: Process pair, Actions, Abort backup path, Abort disk, Abort primary path, Backup path disk pair primary path process pair, Abort backup path abort disk abort primary path
Backup Path
Indicates whether the disk is active or inactive.
Access State
The
to which the backup path is configured.
Configured CLIM
The logical unit number of the disk.
Example: 101
LUN
Disk Pair
The name and location of the mirrored disk.
Example: Disk $SAS25-M.
Disk Pair Name
Primary Path
Indicates whether the disk is active or inactive.
Access State
The
to which the primary path is configured.
Configured CLIM
The logical unit number of the disk.
Example: 101
LUN
Process Pair
The state of the backup I/O process.
Values: Running, Stopped
Backup Execution State
The process ID of the backup I/O process. If the state of the backup I/O
process is Stopped, this ID is not displayed.
Example: 1,285
Backup Process ID
The 2 processors in which this I/O process is configured to run.
Example: 0,1
Configured Processors
The state of the primary I/O process.
Values: Running, Stopped
Primary Execution State
The process ID of the primary I/O process. If the state of the primary I/O
process is Stopped, this ID is not displayed.
Example: 1,296
Primary Process ID
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is
in a Hard Down state. You must use the Reset Backup Path action before you can start the path
again.
Abort Disk
Terminates operation of all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is
in the Stopped state.
118
System Resources