HP Integrity NonStop J-Series - Manual (Page 119)

Clear Data
Available only for SAS or SSD disks -- Erases all data on the disk but leaves the disk label intact.
Clear Data does not erase the FIR data in the CE sector, the volume label, the boot sector, or the
spare tracks table. After a Clear Data completes or is cancelled, the disk drive is not usable until
you restore the file system by using the SCF INITIALIZE DISK command.
The action prompts you to specify an optional process priority for the action. If not specified, the
current default priority is used.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk
was in a STOPPED state, substate HARDDOWN; a hardware error has occurred; the disk was
stopped with an ABORT command; or a STOP or ABORT fails to put the disk into the STOPPED
state, substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Save as System Load Configuration
Specifies, within OSM, this disk as an alternate system load volume. For NonStop BladeSystem
NB54000c and NB56000c only, if the action passes and a valid core license file is present in
$SYSTEM, OSM offers to copy the license file copied to each new alternate system disk.
You can specify up to four such alternate system load configurations. Each one is displayed under
the system attributes in the OSM Service Connection and can be selected from within the System
Load dialog box in the OSM Low-Level Link.
NOTE:
•
This action will fail if performed on a partitioned disk.
• With OSM Low-Level Link T0633 AAQ and later, you can also save system configuration files
on the system console. Those saved configurations are not displayed as attributes values in
the OSM Service Connection, but can be used during the system load operations in the
Low-Level Link. For more information, see the OSM Low-Level Link online help.
Set LED State
Sets the LED on the physical disk in the SAS disk enclosure to On or Off.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in
the started State.
Start Disk
Starts all paths to this disk drive. When the Start action completes, all paths are in the Started state.
Disk (CLIM-Attached) 119