HP LP2465 24-inch Widescreen LCD Monitor - Manual (Page 56)

Troubleshooting
Problem Possible Cause Solution
Image appears
blurred, indistinct, or
too dark. Brightness and contrast
are too low. Press the -/Auto button on
the front panel. If this does
not correct the image, press
the Menu button to open the
Basic OSD Menu, and
adjust the brightness and
contrast scales as needed.
Image is not
centered. Position may need
adjustment. Press the Menu button to
access the OSD menu.
Select Image Control/
Horizontal Position or
Vertical Position to adjust the
horizontal or vertical
position of the image.
“Check Video
Cable” is displayed
on screen. Monitor video cable is
disconnected. Connect the DVI-D signal
cable to the DVI-I connector
on the computer, or the
VGA to DVI-I cable to the
DVI-I connector on the
computer. Be sure that the
computer power is off while
connecting the video cable.
“Out of Range. Set
Monitor to 1600 x
1200 @ 60Hz” is
displayed on screen.
(HP LP2065 20”
Model) Video resolution and/or
refresh rate are set
higher than what your
monitor supports. Restart your computer and
enter Safe Mode. Change
your settings to a supported
setting (see “Factory Preset
Display Modes” table in
Appendix B). Restart your
computer so that the new
settings take effect.
A–2 User Guide