HP XP Command View Advanced Edition Software - Manual (Page 171)

Performing Storage Subsystem Operations 171
• Fibre Addr: In fabric environments, the port address is assigned automatically by fabric switch port
number and is not controlled by the StorageWorks XP1024/XP128 port settings. In arbitrated loop
environments, the port address is set by entering an AL-PA (or loop ID). Refer to
Table 10-1 for the
available AL-PA values.
• Channel speed: 1 GB/s, 2 GB/S, or auto (cannot be modified for some port types)
• Host storage domain settings:
• Host Storage Domain Name: Displays and allows you to change the HSD name, which can be a
maximum of eight characters. You can use only the following characters for the name:
A-Z
, a-z, 0-9, !, #, $, %, &, ', (, ), +, -, ., =, @, [, ], ^, _, `, {, }, ~
You can use spaces, but you cannot specify a space before and after the HSD name and you cannot
specify space characters only.
• Host Mode: Solaris™, HP, AIX ® , Windows ® , NetWare ® , etc. Select the host mode for the connected
platform to enable the host to “see” all LUNs on the port. For details on the host mode, see the LAN
Management manual for StorageWorks XP1024/XP128.
NOTE: If Device Manager cannot recognize the host mode specified for the host storage domain,
Unknown is displayed.
NOTE: Selectable host modes vary depending on the microcode version.
• LUN Security: Host name/WWN for each WWN in the selected host storage domain
• WWN Info button: Displays the WWN(s) registered to the port ( Figure 10-22 )
Figure 10-22 World Wide Name Information Panel for the StorageWorks XP1024/XP128
The Port Information Panel for StorageWorks XP512/XP48:
• LUN security: Enable or disable LUN security for all LUNs on the port. To secure LUNs, select Enabled.
If no LUN security at all is desired, you can select Disabled.
• Topology (Fabric): On, Off
• Topology (Connection): FC-AL, Point-to-point
• Fibre address. In fabric environments, the port address is assigned automatically by fabric switch port
number and is not controlled by the XP512/XP48 port settings. In arbitrated loop environments, the port
address is set by entering an AL-PA (or loop ID). Refer to
Table 10-1 for the available AL-PA values.
• Host mode: Solaris™, HP, AIX ® , Windows ® , NetWare ® , etc. Select the host mode for the connected
platform to enable the host to “see” all LUNs on the port. For details on the host mode, see the LAN
Manager manual for StorageWorks XP512/XP48.
NOTE: If Device Manager cannot recognize the host mode that is specified for the port, Unknown is
displayed.
• Modify LUN Group: Opens the Modify LUN Group panel (see section 10-3-2 )