Avanti EWC801 - Manual (Page 5)

5
IMPORTANT SAFETY INSTRUCTIONS

WARNING

To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
• Read all instructions before using the Wine Chiller.
• DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will “just sit in the garage a few days”.
• Before you throw away your old Wine Chiller: Take off the door. Leave the
shelves in place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create a fire
hazard or explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other appliance. The fumes can create a fire hazard or explosion.
• Do not repair or replace any part of the wine chiller or attempt any servicing unless
specifically recommended in the user-maintenance instructions or in published user-
repair instructions. Replace the fuse with the same type.
-Save these instructions-
INSTALLATION INSTRUCTIONS

• Remove the exterior and interior packing. Before Using Your Wine Chiller
• Check to be sure you have all of the following parts:
Model EWC801 Model EWC1201
(3) Shelves (2) Standard Shelves
(1) Vertical shelf
(1) Instruction Manual (1) Instruction Manual
• Clean the interior surface with lukewarm water using a soft cloth.

• This Wine Chiller is designed to be free standing installation only, and should not be recessed or
built-in (Fully recessed).
Installation of Your Wine Chiller
• Place your Wine Chiller on a surface that is strong enough to support it when it is fully loaded.
• Allow 5 inches of space between the back and sides of the wine chiller, which allows the proper
air circulation to cool the heat sink.
• Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• This Wine Chiller uses superconductor refrigeration technology (no compressor) and is not
designed for storage in hot areas like garages, warehouses or outdoors since it is designed to
operate at a maximum of 30 degrees below the ambient temperature.
• Avoid locating the unit in moist areas.
• Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
• After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3 hours before