HP Compaq NC3123 Fast Ethernet NIC PCI Adapter - Manual (Page 14)

Installing the Adapter 2-3
Connecting the Network Cable
The NC3123 Server Adapter has one RJ-45 port for 32-bit PCI 10/100 operation. Network
connections for this adapter can employ existing UTP Category 5 (or better) cable for 100 Mb/s
operation, and Category 3 (or better) cable for 10 Mb/s operation.
To secure the cable, plug the cable connector into the RJ-45 port. Ensure that the tab on the plug
clicks into position, indicating that it is properly seated.
For more information, see the section, “UTP Cable Specifications” in Appendix C.
To configure the NC3123 Server Adapter, continue with the procedures specific to your
operating system as described in the Network Adapter Software and Configuration Guide on the
HP website (
http://www.hp.com ).
Connecting the Wake on LAN Power Cable
NOTE: If your server is PCI 2.2 Hot Plug compliant, you do not need to install a Wake on LAN (WOL)
power cable. However, you may need to set up the system BIOS to enable the WOL feature. See the
section, “Configuring the WOL Feature and Installing the WOL Power Cable.”
For the WOL feature to work correctly, the NC3123 Server Adapter must be connected to a
continuous power source. This allows the adapter to listen to the network even when the
computer is powered down.
WARNING: Before installing the WOL cable, power down the server and unplug the power
cord. Failure to do so could damage the NC3123 Server Adapter or the server. The WOL
connector on your motherboard is live when the server is plugged into a power outlet.
Configuring the WOL Feature and Installing the WOL Power Cable
Some servers may require you to change a setting in the BIOS or Setup program to enable the
WOL feature. If your system is PCI 2.2 Hot Plug compliant, follow these steps to set up the
BIOS to enable the WOL feature.
1.
Check your server owner’s manual or contact your dealer for more information.
2.
Replace the server cover and plug the power cord into the power outlet.
If your system is not PCI 2.2 Hot Plug compliant, follow these steps to install the WOL power
cable.
1.
Ensure that your server is unplugged from the power outlet.
2.
Locate the WOL connector on the NC3123 Server Adapter. Attach one end of the WOL
cable to the adapter as shown in Figure 2-2. Note that the connector is keyed.