HP ProLiant BL660c Gen8 Server Blade - Manual (Page 14)

Operations 14
Remove the access panel
To remove the component:
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Press the access panel release button.
4. Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
Remove a drive
1. Back up all server blade data on the drive.
2. Remove the drive.
Removing DIMM baffles
CAUTION: To avoid damage to the server blade and the enclosure, install all DIMM baffles in
the proper location after adding or replacing DIMMs. DIMM baffles that are missing or installed
incorrectly can compromise server blade and enclosure cooling.
The server blade contains three DIMM baffles.
Remove the center DIMM baffle
To remove the component:
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Remove the access panel (on page 14 ).
4. Disconnect any cables that may be routed across the DIMM baffle.