HP StorageWorks XP Remote Web Console Software - Manual (Page 260)

8-26 Chapter 8 Performing Pair Operations
Hitachi Universal Replicator for IBM /OS User’s Guide
Releasing a Pair of Data Volumes
The Delete Pair window (Figure 8-8) allows you to release a pair of data
volumes.
When one journal group uses two mirror IDs, the result of the operation differs
as follows according to the status of the mirror of specified URz pair.
• When you specify a mirror of the URz pair in Hold or Hlde status, only the
URz pair of the specified mirror will be deleted.
• When you specify a mirror of the URz pair that is not in Hold or Hlde
status, URz pairs of both mirrors (including the mirror which you do not
specified) will be deleted.
To release one or more pair(s), follow the procedure below. Not only the
primary storage system administrator but also the secondary storage system
administrator can perform this operation:
1. Ensure that the Storage Navigator main window is in Modify mode.
For detailed information about how to do this, please refer to Storage
Navigator User’s Guide.
2. Ensure that the Pair Operation window is displayed.
3. In the tree, select a CU image number.
4. In the list, select and right-click the pair that you want to release.
5. From the pop-up menu, select Delete Pair.
The Delete Pair window appears (Figure 8-8).
6. In the Delete Pair window, select the desired options for the pair(s).
7. Select Set to close the Delete Pair window.
8. See the Preview list in the Pair Operation window to check the settings
that you have made.
– If you want to modify a setting, select and right-click the setting and
then select Modify.
– If you want to cancel a setting, select and right-click the setting and
then select Cancel.
9. Select Apply to release pair(s).
Note: If an error occurs, the rightmost column of the Preview list displays
the error code. To view detailed information about the error, right-click the
error code and then select Error Detail. An error message appears and
gives you detailed information about the error.
10. In the list of the Pair Operations window, verify that the pair(s) has been
released successfully. If the pair has been released, the status of the pair is
Simplex.