HP MPX200 Multifunction Router - Manual (Page 31)

Syntax
list vlan
Example
c:\> rcli list vlan /ip=10.0.0.12
[10.0.0.12]
-port=1 -ipv4 -enable=yes -id=32 -priority=2
-port=2 -ipv4 -enable=no
-port=3 -ipv4 -enable=no
-port=4 -ipv4 -enable=no
-port=1 -ipv6 -enable=no
-port=2 -ipv6 -enable=no
-port=3 -ipv6 -enable=no
-port=4 -ipv6 -enable=no
list vp_group
The list vp_group command lists the names of all VP groups known to the router.
NOTE: This command is not supported for MPX100 routers.
TIP: To view details for a single VP group, use the show vp_group command.
Syntax
list vp_group
Example
c:\> rcli list vp_group /ip=10.0.0.12
[10.0.0.12]
VpGroup count = 4
-vpgindex=1 "VPGROUP_1" (enabled)
-vpgindex=2 "VPGROUP_2" (enabled)
-vpgindex=3 "VPGROUP_3" (enabled)
-vpgindex=4 "VPGROUP_4" (enabled)
login iscsi_target
The login iscsi_target command
Syntax
login iscsi_target
NOTE: This command requires router firmware version 3.2.3.0 or later.
Keywords
Specifies the port number for the outbound iSCSI port. -port
Specifies that CHAP is enabled for this initiator. If this keyword is not used, the default
is disabled. Values are: -chap_enable=
•
yes
•
no
•
on
•
off
list vp_group 31