HP XP7 Storage - Manual (Page 126)

4. In the Edit SSIDs window, click OK.
5. In the Create LDEVs window, click Finish.
6. In the Confirm window, confirm the settings, and then click Apply.
If Go to tasks window for status is checked, the Tasks window opens.
Changing THP V-VOL settings
The Storage Administrator (Provisioning) role is required to perform this task.
Before registering a THP V-VOL, you may need to change the THP V-VOL settings.
1.
In the Selected LDEVs table in the Create LDEVs window, select an LDEV, and then click Change
LDEV Settings.
2. In the Change LDEV Settings window, you can change the setting of LDEV Name, Initial LDEV
ID, or MP Blade.
•
If you change LDEV Name, specify the prefix characters and the initial number for this
LDEV.
•
If you change Initial LDEV ID, specify the number of LDKC, CU, DEV, and Interval. To
check used LDEVs, click View LDEV IDs to confirm the used LDEVs. The View LDEV IDs
window opens.
CAUTION: You cannot change the LDEV ID when you select a TSE-VOL in one of the
following conditions:
◦ Selecting TSE-VOLs and other volumes at the same time.
◦ Selecting together the TSE-VOL related to the pool whose ID is the odd number and
the TSE-VOL related to the pool whose ID is the even number.
•
If you change MP Blade, click the list and specify the MP blade ID. If the specific MP
blade is specified, select the MP blade ID. If any MP blade is specified, click Auto.
3. Change the settings, and then click OK.
4. In the Create LDEVs window, click Finish.
5. In the Confirm window, click Apply.
The setting is changed.
If Go to tasks window for status is checked, the Tasks window opens.
Removing the THP V-VOL to be registered
The Storage Administrator (Provisioning) role is required to perform this task.
If you do not want to register the THP V-VOL, you can remove it from the registering task.
1.
In the Selected LDEVs table in the Create LDEVs window, select the LDEV, and then click Remove.
The message appears asking whether you want to remove the selected row or rows. Click
OK.
2. Click Finish.
3. In the Confirm window, click Apply.
The LDEV is removed.
If Go to tasks window for status is checked, the Tasks window opens.
126 Configuring thin provisioning