Alvin Split Top Drafting Tables Titan II - Manual (Page 2)

To Assemble Base Frame
Unpack and inspect contents to confi rm
you have all the parts listed. Use care to
differentiate the four crossbars from each
other, as shown in the parts list. Also use care
to differentiate left side frame from right, as
shown in the parts list.
Attach rear crossbars (
B
and
C
), footrest
crossbar (
E
), and front crossbar (
D
) to one
side frame (
A
) using 2" Allen bolts (
G
) to one ) to one
). Pay
close attention to correct orientation of all pre-
drilled holes. Tighten securely.
Attach other side frame to opposite ends
of four crossbars in step two using 2" Allen
bolts. Tighten securely.
Attach angle brackets (
K
) to inside surfaces
of front and rear crossbars, using 3/4" Phillips
screws ( L ) into pre-drilled holes, as shown in
diagram. Keep slightly loose for time being.
Attach hinges ( I ) to outside surface of front
crossbar using 3/4" Phillips screws as shown
in diagram. Keep these screws slightly loose
for time being.
1
2
3
4
5
Attach hinges to inges inges
front crossbar ff
2
B
C
D
E
Attach angle brackets
K K
I