Error messages, Table 9.12 – HP Jetdirect 250m Print Server series User Manual

Page 172

Advertising
background image

ENWW

HP Jetdirect Configuration Page 25

Error Messages

Error codes and messages that may appear in the Status sections
of the Jetdirect configuration page are described in

Table 9.12

. +

Table 9.12

Error Messages (1 of 10)

Error Code and
Message

Description

02 LAN ERROR -
INTERNAL
LOOPBACK

During self-test, the HP Jetdirect print server detected an
internal loopback test error. The print server may be faulty.
If the error persists, replace the HP Jetdirect print server.

03 LAN ERROR -
EXTERNAL
LOOPBACK

The HP Jetdirect print server is incorrectly connected to
your network or is defective. Make sure your HP Jetdirect
print server is correctly attached to your network. In addition,
check the cabling and connectors.

07 LAN ERROR -
CONTROLLER CHIP

Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.

08 LAN ERROR -
INFINITE DEFERRAL

There is a network congestion problem.

Note: If the print server is not connected to the network, this
error cannot occur.

09 LAN ERROR -
BABBLE

Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect print
server. For replacement instructions, see the hardware
installation guide for your print server.

0A LAN ERROR -
NO SQE

Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.

0C LAN ERROR -
RECEIVER OFF

There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.

0D LAN ERROR -
TRANSMITTER OFF

There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.

Advertising
This manual is related to the following products: