Anton/Bauer DUAL 2722 - Manual (Page 12)

OPERATION AS DC CAMERA SUPPLY FROM MAINS
The DUAL 2722 can operate cameras and camcorders using the four pin camera
output connector located on the back of the DUAL 2722. To power the camera,
attach one end of the XLR4 accessory cable (available separately) to the DUAL 2722.
Attach the other end to the “DC in” four pin XLR on the camera/camcorder. Move
the switch located next to the connector to the “CAMERA” position.
The DUAL 2722 will remember the point at which it left its charge routine for the
battery positioned on the right side of the charger. The left side of the charger will
continue as a dedicated charging position, regardless of the selected function of the
right side of the DUAL 2722. When the switch is returned to the “CHARGER”
position, the batteries will automatically continue charging where they left off.
During camera operation, with batteries on the PowerCharger, the unit will indicate a
solid RED LED for the right battery position. The right hand side of the display will
indicate “CAMERA MODE”.
10