HP ProLiant BL680c G5 Server-Blade - Manual (Page 15)

Operations 15
Install the access panel
1. Place the access panel on top of the server blade with the hood latch open. Allow the panel to
extend past the rear of the server blade approximately 0.8 cm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
Remove the FBDIMM baffle
CAUTION: To avoid damage to the server blade and the enclosure, install all FBDIMM baffles
in the proper location after adding or replacing FBDIMMs. FBDIMM baffles that are missing or
installed incorrectly can compromise server blade and enclosure cooling.
To remove the component:
1. Power down the server blade (on page 13 ).
2. Remove the server blade (on page 14 ).
3. Remove the access panel (on page 14 ).
4. Remove the FBDIMM baffle:
o FBDIMM baffle covering FBDIMM slots 1-8