HP P6000 Continuous Access Software - Manual (Page 61)

More help
•
Overview. See About topology views .
•
Tips. See topology view Tips .
•
Filters. See Filters for views .
Filters for topology views
There can be many resources in a default view. To simplify a view, you can create a managed
set then select it as a filter for the view.
In the following example, a filter is applied to a complex view. The example filter is a managed
set of virtual disks that includes three disks.
Sample view with a filter Sample view without a filter
Applicable filters
The following table identifies the types of managed sets that are applicable to each view. If you
select a filer that is not applicable to a view, the view is not filtered.
Applicable managed set filter
View
Virtual
disks
Storage
systems Host
volumes
Enabled
hosts
DR groups
Yes Yes - - Yes DR groups view
Storage Systems > DR Groups > Virtual Disk
- - Yes Yes - Host volumes view
Enabled Hosts > Host Volumes > Virtual Disks
Yes Yes - - Yes Virtual disks view
Storage Systems > Virtual Disks
More help
•
General information. See About managed sets .
•
Procedures. See Creating managed sets and Adding resources to a managed set .
Tips (topology views)
General
IMPORTANT: Do not use browser buttons to refresh the topology view or to navigate. Using
browser buttons will end the session. See troubleshooting Browser window is blank . The view is
automatically refreshed from the replication manager database every 15 seconds. See also
Automatic refresh of resources .
Topology views 61