HP Remote Assistant Card - Manual (Page 72)

2 Hardware Installation and Configuration
54
Press Enter to send the test page to administrator aliases in the list. When the paging
is complete, the Configuration Utility displays a dialog box informing you that the
page was sent. If the page is not received, try editing the Pager# string in the Edit
Administrator window to change the number of pauses that specify the connection
delay. If you are using a TAP pager, check the service phone number, the pager ID
and the password. Also, check to make sure that the modem is connected to the
telephone jack.
Testing the Power Connection
The Diagnostics Menu provides a Test Power Control Cable command that you can
use to verify that the power control cable on the HP Remote Assistant board has been
properly attached to the power adapter on the server. If the cable has been properly
connected, the HP Remote Assistant board will "power cycle" (turn off for about 15
seconds, then turn on) the server to verify the connection.
When you choose Test Power Control Cable from the Diagnostics Menu, the
Configuration Utility displays the Test Power Control Cable window and asks you to
confirm the test.
Press Enter to perform the test. If the power control cable has been properly attached,
HP Remote Assistant asks if you want to save the current configuration before it power
cycles the server.
If HP Remote Assistant is unable to power cycle the server, an Error dialog box
appears, informing you that the power control cable is not properly connected, or that
the server in which the HP Remote Assistant board is installed does not support the
feature. If the test failed, check the HP Remote Assistant board installation and verify
that the power control cable is properly connected to both the HP Remote Assistant
board and the server, and that you have specified the power control cable as being
connected in the Event Management window.