HP SAN - Manual (Page 30)

Figure 11 Data Collection window
Data collection methods
The SAN Visibility uses the following two methods for data collection:
• SNMP based data collection
• SMI-Agent based data collection (for Brocade switch)
SNMP based data collection
The SNMP based data collection is the default data collection method used by SAN Visibility.
SMI-Agent based data collection (for Brocade switch)
If you want to use the SMI-Agent based data collection method, then provide the CIMOM server
details as discussed below. The SAN Visibility allows only local user accounts to retrieve data from
the Brocade SMI-Agent (if the user authentication option is enabled at the Brocade SMI-Agent).
If the SMI-Agent based data collection fails to run, then the SAN Visibility uses the SNMP based data
collection method.
NOTE:
Ensure that SMI-Agent (120.6.0 a) is installed and running in the machine. To start the CIMOM server,
select Start > Program > SMIAgent120.6.0a > Start CIMOM.
To enter CIMOM server setting details, complete the following steps:
Using SAN Visibility 30