HP f2304 23-inch High Def LCD Monitor - Manual (Page 17)

Setting Up the Monitor
User’s Guide 3–7
Mounting the Monitor
1. Remove the monitor base. Refer to “Removing the
Monitor Base” steps in the previous section.
2. With the base is removed, use the four threaded screw
holes on the monitor panel to mount the monitor. The
mounting holes are spaced 4 inches (10.2 cm) apart.
✎
Mount the monitor to a swing arm or other mounting fixture
by following the instructions included with the mounting
fixture to be used.
Removing the Side Panel
On the back of the f2304 monitor there are several
connectors behind the side panel.
To remove the side panel:
1. Gently pull on the edge of the side panel.
2. Slowly ease the tabs around the side panel out of the tab
slots as shown in the following illustration.