HP Officejet J5740 All-in-One Printer - Manual (Page 153)

3. In the Copy area, press Quality until the appropriate quality setting is lit.
4. Press Start Copy Black or Start Copy Color.
To change the print speed or quality
1. Make sure you have paper loaded in the input tray.
2. From the File menu in your software application, choose Print.
3. Make sure the HP All-in-One is the selected printer.
4. From the pop-up menu, choose Paper Type/Quality.
5. Click the Paper tab.
6. From the Paper type pop-up menu, choose the type of paper loaded in the input
tray.
7. From the Quality pop-up menu, choose the appropriate quality setting for your
project.
For more information about changing quality settings, see the HP Officejet J5700 All-
in-One series Help section in the HP Photosmart Software Help.
Cause: The paper type is not suitable for the HP All-in-One.
Solution: If the paper you are using is too fibrous, the ink applied by the HP All-in-
One might not fully cover the surface of the paper. Use HP Premium Papers or any
other paper type that is appropriate for the HP All-in-One.
For more information on choosing paper, see
Understand specifications for supported
media .
Cause: The Lighter / Darker copy setting for the HP All-in-One is set too light.
Solution: Adjust the lightness and darkness of the copies.
To adjust the copy contrast from the control panel
1. Make sure you have paper loaded in the input tray.
2. Load your original print side down on the right front corner of the glass or print
side up in the document feeder tray.
If you use the document feeder tray, place the pages so that the top edge of the
document goes in first.
3. In the Copy area, press Menu repeatedly until Lighter / Darker appears.
4. Do one of the following:
•
Press to darken the copy.
• Press to lighten the copy.
5. Press Start Copy Black or Start Copy Color.
Cause: The Paper Type setting is incorrect.
Print quality troubleshooting 151