HP Photosmart C4435 All-in-One Printer - Manual (Page 205)

5. Try to print from your computer.
If the product prints when plugged directly into a power outlet while disconnected
from any power strips or surge suppressors, the power strip or surge suppressor
might not be allowing sufficient voltage to reach the product.
6. If the product cannot print and the print carriage is still stalled, contact HP support
for service.
Go to:
www.hp.com/support .
If prompted, choose your country/region, and then click Contact HP for
information on calling for technical support.
Cause: There might not be sufficient voltage for the product.
If this did not solve the issue, try the next solution.
Solution 5: Print a self-test report
Solution: Print a self-test report to see if the product can print.
If the product can print a self-test report and can print from the computer (if applicable),
then there is no need to follow the remaining solutions, as the error message might
be false.
For more information, see:
“Print a self-test report” on page 69
Cause: The error was false.
If this did not solve the issue, try the next solution.
Solution 6: Reset the product
Solution: Turn off the product, and then unplug the power cord. Plug the power
cord back in, and then press the On button to turn on the product.
To reset the product
1. Remove all paper loaded in the input tray.
2. Make sure that the product is turned on and remove the USB cable from the back
of the product.
3. Open the print cartridge door.
The print carriage should move to the far right side of the product.
Chapter 13
202 Troubleshooting
T
roub
les
hoot
ing