HP 3PAR System Reporter Software - Manual (Page 76)

Table 10 Controls for Each Report (continued)
Adaptive
Optimization Link
Perf CPU
Perf Node
Cache
Perf VV
Cache
Perf VLUN
Perf LD
Perf Port
Perf PD
Perf VV
Space LD
Space CPG
Space PD
Space Summary Report:
Section and
Control
Y Y Y Y Y Y Y Y Y Y Y Y Y “Chart Y
Pixels”
(page 96)
T T T T T T T T T T T T “Time
Labels”
(page 96)
Y Y Y Y Y Y Y Y Y Y Y Y Y “Legend
Position”
(page 96)
T T T T T T T T T T T T “Time
Format”
(page 96)
Y Y Y Y “Select
Space
Unit”
(page 97)
Detailed descriptions for each of the controls described in this table are provided in the following
sections.
Report Selection
For each report except for the Summary Report, you can use the Report Type pull-down list to
choose a report type. There are two selections of report types: standard report types and adaptive
optimization report types that only apply to the Adaptive Optimization feature that is available
through an optional license with System Reporter.
Standard Report Types
The following standard report types are available ( Table 11 (page 76) ):
Table 11 Standard Report Types
Purpose Report Type
Display metrics versus time. The beginning of the time range is specified by the Begin/At
Time control (see
“Begin/At Time” (page 84) ) and the end of the time range is specified
by the End Time control (see “End Time” (page 85) ).
Versus Time
Unless the Compare control is available and set to something other than none, the
Versus Time report shows aggregate metrics for all the selected objects over a range
of time. See Figure 28 for an example.
If the Compare control (see section “Compare” (page 81) ) is set to a specific object,
then the Versus Time report plots the metrics separately for each of up to 16 of the
objects so that they can be compared. Figure 29 shows an example where the
performance of systems is being compared.
Display metrics at the time specified by the Begin/At Time control (see “Begin/At Time”
(page 84) ). For this type of report, the Group By (see section “Group By” (page 82) )
At Time
and Order By (see section “Order By” (page 83) ) controls are enabled and can be
used to compare different groupings of object type. “Group By System:Host At Time
Report Example” (page 79) shows an example of an example with System and Host
selected in the Group By control and IOPs/s selected in the Order By control.
Display service time histogram versus time, with a separate data series for each service
time bucket between the Low Bucket (see
“Low Bucket” (page 84) ) and the High Bucket
(see “High Bucket” (page 84) ).
Histogram Versus Time
76 Accessing and Creating Reports