HP 3PAR Geocluster Software - Manual (Page 20)

3PAR GeoCluster 1.0.0.14 for Windows User’s Guide
320-200263 Page 20
Click the Parameters tab
Set the Parameters tab as follows:
1 Distribute the nodes between the Site A and Site B fields, to reflect where they are physically
located.
2 In the Site A group box, enter the IP address of the InServ storage array present on the local
site, the name of the Remote Copy Group it hosts and the login and password required to
access its CLI.
3 In the Site B group box, enter the IP address of the InServ storage array present on the
remote site, the name of the Remote Copy Group it hosts and the login and password
required to access its CLI.
4 Validate the changes by clicking OK.
NOTE: Validating the changes made to the resource’s parameters will
initiate verifications on the node owning the resource at the time of the
validation, against the InServ storage array located on the same site. The IP
address, the Remote Copy group and the login and password will be
checked. If any of these do not pass verification, 3PAR GeoCluster for
Windows resource cannot be brought online.