HP ProLiant ML350 G6 Server - Manual (Page 62)

Hardware options installation 62
o The connector labeled "6LFF"of the mini-SAS Y-cable to the primary hard drive cage.
10. Slide the optional hard drive cage fully into the bay until it clicks, and then install the screws.
CAUTION: Always populate each media bay with either a device or a blank. Proper airflow can
only be maintained when the bays are populated. Unpopulated drive bays can lead to improper
cooling and thermal damage.
11. Connect the common end of the mini-SAS Y-cable to the SAS connector B on the system board.
12. Install any hard drives or blanks (" SAS or SATA hard drive option " on page 52 ).
13. Install the access panel (on page 27 ).
14. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
15. Power up the server (on page 24 ).