HP LaserJet Pro 400 color Printer M451 series - Manual (Page 61)

HP Smart Install for Windows wireless networks, method 1: Temporarily
connect a USB cable
1. Connect an A-to-B type USB cable to the computer and the product. The HP Smart Install
program might take a few minutes to start.
2. Follow the onscreen instructions. Choose wireless network for the install type. Remove the
USB cable when instructed.
HP Smart Install for Windows wireless networks, method 2: Use WPS
1. On the front of the product, press the Wireless buttonto open the Wireless Menu options.
2. Press the OK button to select the Wireless Off/On option, and then press the right arrow to
select the On option. Press the OK button to save the setting.
3. Press the right arrow to select the WPS Setup option, and then press the OK button. Follow the
instructions to complete the wireless setup.
4. On the product control panel, the product IP address alternates with the Ready message on the
display. Make note of the IP address.
5. At the computer, open a Web browser and type the IP address in the URL address bar to open
the HP Embedded Web Server. Click the HP Smart Install tab and follow the onscreen
instructions.
Connect with USB
NOTE: Use this procedure if you are not using the HP Smart Install.
This product supports a USB 2.0 connection. Use an A-to-B type USB cable. HP recommends using
a cable that is no longer than 2 m (6.5 ft).
CAUTION: Do not connect the USB cable until the installation software prompts you to connect it.
CD installation
1. Quit all open programs on the computer.
2. Install the software from the CD, and follow the on-screen instructions.
3. When prompted, select the Directly connect to this computer using a USB cable option, and
then click the Next button.
ENWW Connect with USB 43