HP ProLiant DL580 G7 Server - Manual (Page 62)

Hardware options installation 62
7. Install the PCI Express I/O expansion board.
8. Install any expansion boards (" Installing a non-hot-plug expansion board " on page 57 ).
9. Install the access panel.
10. Slide the processor memory drawer back into the server.
11. Slide the server back into the rack.
12. Power up the server (on page 25 ).
Installing the PCI-X/PCI Express I/O expansion board
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all expansion slots have either an expansion slot cover or an expansion board installed.
IMPORTANT: When either optional I/O expansion board in installed in a two-processor
configuration, the second processor must be installed in socket 3.
1. Power down the server (on page 25 ).
2. Extend the server from the rack (on page 25 ).
3. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
("
Processor memory drawer shipping screw locations " on page 27 ).