Acoustic Research wireless speakers AW877 - Manual (Page 13)

Accessing the Speaker Battery Compartments
There are two options to power your wireless speakers: using the included
AC power adapters or using 8 C-cell batteries per speaker (not included). The
Installation and Operation Manual takes you through the steps to do both on page 5.
The Installation and Operation Manual does not include instructions for accessing
the battery compartment on each speaker.
To remove a speaker battery compartment cover:
1. Lay the speaker gently on its front.
2. Use a Phillips-head screwdriver to loosen the
compartment cover screws.
3. Hold the battery compartment cover and turn
the speaker over. The screws should fall out.
If they don’t, lay the speaker on its front again
and loosen the screws a little more.
Important: Don’t lose the screws! You’ll need
them to put the battery compartment cover
back on.
4. Put the speaker on its front again. Remove the
battery compartment cover.
5. Insert eight (8) C-cell batteries (not included)
in the speaker following the polarity (+ and –)
diagram inside the compartment.
Speaker Battery
Compartment Cover
Cover
Screws
Speaker Back
To replace the speaker battery compartment cover:
1. Put the battery compartment back in place.
2. Put the screws back in the holes on the battery compartment cover. Use a
Phillips-head screwdriver to tighten the compartment cover screws.
Addendum to the Installation Manual
AW877_TIS2_00