HP Latex 850 Printer User Manual
Page 11
9.
Open the latches at both ends of the spindle (if they were closed) and push the roll on its spindle
into the printer.
10.
Close the latches to secure the spindle in place.
TIP:
If you cannot close the gear side latch, try sliding the spindle towards the side plate to make
sure the end flange is not sitting on the bearings.
11.
In the same way, load the spindle with the empty cores into the front of the printer. In this case, the
geared end of the spindle should be on the right.
12.
Check that the printer has finished raising the carriage beam.
13.
Pass the leading edges of both rolls through the printer to the output spindle.
TIP:
LX850/LX820 only: Use the Media Loading Tool to load both rolls through the media
path at the same time.
ENWW
Load rolls into the printer
7
Dual-r
oll spindle