Before you begin – HP IO Accelerator for BladeSystem c-Class User Manual
Page 11
Introduction 11
Average block size
(bytes)
Minimum system RAM
requirement for 640 GB
MezzIO Accelerator*
Minimum system RAM
requirement for 785 GB
MezzIO Accelerator*
Minimum system RAM
requirement for 1.2 TB
MezzIO Accelerator*
512
22.8 GB
31.2 GB
47.6 GB
* For IO Accelerator use only. Additional RAM is needed for system operating system and applications.
HP PCIe IO Accelerator Duo requirements
In addition to the IO Accelerator cooling and RAM requirements listed in the previous table, the IO
Accelerator Duo requires at least:
•
A PCIe Gen1 x8 slot or a PCIe Gen2 x4 slot
•
A minimum of a full-height, half-length slot with a x8 physical connection. For systems with PCI 1.1, all
eight signaling lanes must be active for full IO Accelerator Duo performance. For systems with PCIe 2.0,
only four signaling lanes must be active for full performance.
NOTE:
With driver version 3.1.0 and later, the driver detects in the BIOS if the PCIe slot supports
a 75W power draw. If the slot supports up to 75W, the IO Accelerator device draws up to that
amount of power. However, if an external power cable is used, power is only supplied by that
cable.
To verify whether a slot is supplying 75W, view the system logs or use the fio-pci-check
utility.
Before you begin
Before installing the IO Accelerator driver, be sure you have properly installed the IO Accelerator devices.
For more information, see the hardware installation instructions that came with your IO Accelerator.
After you install this version of the IO Accelerator driver, you might have to upgrade the firmware to enable
operation. For more information, see "Upgrading firmware ("
Upgrading the firmware using ESX
" on page
)."
IO Accelerators cannot be installed as part of an ESX or ESXi installation.