HP x2401 24-inch LED Backlit Monitor - Manual (Page 8)

2 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, and then follow the instructions below.
Extending the Monitor Stand
1. Lift the monitor from its box and place it face down on a flat surface.
2. Grasp the stand and pull upward until fully extended.
CAUTION: Do not touch the surface of the panel. Pressure on the panel may cause permanent
non-uniformity of color or disorientation of the liquid crystals.
Figure 2-1 Extending the monitor stand
3. Place the monitor in an upright position on a flat surface so that the feet are touching the surface.
Press down firmly on the top center area of the monitor to ensure that the monitor is stable.
2 Chapter 2 Setting Up the Monitor