HP Storage Mirroring Software - Manual (Page 33)

31 of 195
DOUBLETAKEFOLDER="C:\Program Files\StorageWorks\Storage Mirroring"
QMEMORYBUFFERMAX=128
DISKQUEUEFOLDER="C:\Program Files\StorageWorks\Storage Mirroring"
DISKQUEUEMAXSIZE=UNLIMITED
DISKFREESPACEMIN=50
DTSERVICESTARTUP=1
PORT=6320
SET_FWPORT=Y
In the sample DTSetup file, the server Alpha would use the parameters defined under
the [Alpha] heading. The server Beta would use the parameters defined under the [Beta]
heading. All other servers would use the configuration under the [Config] section.
Note:
Do not leave any parameter blank in the Config or MachineName sections.
Otherwise, a hard-coded default stored in a Storage Mirroring Replicate .dll file
will be used.
Review the following table to understand the different parameters available in
DTSetup.ini.
Parameter Valid Values
DTSetupType
●
DTNT—Both the Storage Mirroring Replicate server and
client components will be installed. The server
components are required for systems that will function as
a source, repository server, or recovery server. The
server requires an activation code for the service to run.
The client does not require an activation code, but it is
required to administer this and other servers throughout
the organization.
●
DTCO—Only the Storage Mirroring Replicate client
components will be installed. The client components do
not require an activation code, but are required to
administer servers throughout the organization.
●
DTSO—Only the Storage Mirroring Replicate server
components will be installed. The server components are
required for systems that will function as a source,
repository server, or recovery server. The server requires
an activation code for the service to run.
DTActivationCode
A 24 character, alpha-numeric activation code which applies
the appropriate license to the server