HP Latex 210 Printer User Manual
Page 33
6.
The printer checks the substrate in various ways and may ask you to correct problems with skew or
tension.
NOTE:
You can specify the maximum permitted amount of skew at the front panel: select the
icon, then select Substrate handling options > Max skew setting.
7.
Wait until the substrate emerges from the printer, as shown below.
NOTE:
If you have an unexpected problem at any stage of the substrate loading process, see
the Maintenance and troubleshooting guide.
8.
If you are loading transparent substrate without opaque borders, you are asked to enter the width
of the substrate and the distance of the right edge from the printer's side plate (as indicated by the
ruler on the front of the curing module).
9.
If you have chosen double-sided printing, the front panel may ask a question about it at this point.
10.
The printer calibrates the substrate advance.
11.
The printer indicates that it is ready for printing.
Take care not to cover the top fans.
ENWW
Load a roll into the printer (automatically)
29
Handle the substrate