HP Latex 210 Printer - Manual (Page 51)

Unload a roll from the take-up reel
1. On the printer's front panel, select the icon, then select Take-up reel > Disable take-up
reel.
The printer advances the substrate to allow for cutting.
2. Switch the wind-direction switch to the off position. The switch is in the off position when it is
centered (in other words, when the switch is neither in position 1 nor position 2).
3. Remove the loop-shaper. If you omit this step, it will fall to the floor with the substrate when the
substrate is cut.
To remove the heavy loop-shaper, first lift the support, then press the lever.
ENWW The take-up reel 47
Handle the substrate