HP Latex 210 Printer - Manual (Page 60)

NOTE: If you know that the automatic search for the reference line is not working (perhaps
because the substrate-advance sensor is dirty), you can turn it off: select the icon, then select
Substrate handling options > Auto line detection > Off.
10. Send one or more jobs to be printed on the second side. If you send more than one job, they
should be sent in reverse order, because printing starts at the end of the second side and works
back towards the beginning.
NOTE: The jobs printed on the second side should probably be rotated 180 degrees, and may
need to be slightly reduced in size to compensate for the contraction of the substrate after passing
once through the printer. See also the Maintenance and troubleshooting guide.
View information about the substrate
On the printer's front panel, select the icon, then select View loaded substrate > View
substrate details.
The following information appears on the front panel:
● The roll status
● The substrate family that you have selected
● The width of the substrate in millimeters (estimated by the printer)
If no substrate is loaded, the message Out of substrate appears.
The same information appears on the Embedded Web Server's Supplies page.
56 Chapter 4 Handle the substrate ENWW
Handle the substrate