HP Officejet J3680 All-in-One Printer - Manual (Page 30)

4. Insert the stack of paper into the input tray with the short edge forward and the print
side down. Slide the stack of paper forward until it stops.
CAUTION: Make sure that the device is idle and silent when you load paper into
the input tray. If it is servicing the print cartridges or otherwise engaged in a task,
the paper stop inside the device might not be in place. You could push the paper
too far forward, causing the device to eject blank pages.
TIP: If you are using letterhead, insert the top of the page first with the print side
down. For more help on loading full-size paper and letterhead, refer to the diagram
engraved in the base of the input tray.
5. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.
Load 10 x 15 cm (4 x 6 inch) photo paper
(HP Officejet J3600 only)
You can load 10 x 15 cm (4 x 6 inch) photo paper into the input tray of the device. For
the best results, use 10 x 15 cm (4 x 6 inch) HP Premium Plus Photo Paper or HP Premium
Photo Paper.
TIP: To help prevent rips, wrinkles, and curled or bent edges, store all paper flat in
a resealable bag. If the paper is not stored properly, extreme changes in temperature
and humidity might result in curled paper that does not work well in the device.
For best results, set the paper type and paper size before copying or printing.
Chapter 2
26 Use the device