HP Netserver L Server series - Manual (Page 25)

Chapter 4 Accessory Boards
19
NOTE If you enable NetRAID on only one channel, it is
recommended that you use the default configuration and
enable HP NetRAID on SCSI A. f you enable HP NetRAID on
only one channel, and later want to enable a second channel,
you must follow the instructions in the Integrated HP
NetRAID Controller Configuration Guide in the chapter on
configuring a second channel.
I/0 Memory SE SCSI
SCSI B
SCSI A
Remote
Management
PCI Board
Slots
ISA Board Slot
Figure 4-2. I/O Board With Devices and Bus Structure
NOTE For a list of boards HP has tested with the NetServer, see the
Help topic "Tested Parts List" on the HP NetServer Navigator
CD-ROM.
Installing Accessory Boards
Remove cover 1 from the NetServer. (See Chapter 3, "Removing and Replacing
Covers.")
To install accessory boards:
1. Read the documentation included with each accessory board. Follow any
special instructions and installation recommendations. Some boards have