HP LASERJET PRO P1102w - Manual (Page 54)

Paper orientation for loading trays
If you are using paper that requires a specific orientation, load it according to the information in the
following table.
Paper type How to load paper
Preprinted or letterhead ● Face up
● Top edge leading into the product
Prepunched ● Face up
● Holes toward the left side of the product
Envelope ● Face up
● Left short edge leading into the product
Load paper trays
CAUTION: If you try to print on media that is wrinkled, folded, or damaged in any way, a jam might
occur. See Clear jams on page 83 for more information.
Priority feed slot
The priority feed slot holds up to 10 sheets of media or one envelope, one transparency, or one sheet
of labels or cardstock. Load media with the top forward and the side to be printed on facing up. To
prevent jams and skewing, always adjust the side media guides before feeding the media.
Input tray
The input tray holds 150 pages of 75 g/m 2 (20 lb) paper, or fewer sheets of heavier media (a 15 mm
(0.6 in) stack height or less).
Load media with the top forward and the side to be printed on facing up. To prevent jams and
skewing, always adjust the side and front media guides.
NOTE: When you add new media, make sure that you remove all of the media from the input tray
and straighten the entire stack. This helps prevent multiple sheets of media from feeding through the
product at one time, reducing media jams.
40 Chapter 5 Paper and print media ENWW