ATEN ACS1208 - Manual (Page 21)

9
Chapter 2
Installation
This chapter explains how to connect up your installation — from a basic
single stage hookup to a complete daisy chained setup.
Single Stage Installation
In a Single Stage installation, there are no additional switches daisy chained
down from the first unit. To set up a single stage installation do the following:
1. Plug your keyboard, mouse, and monitor into the unit's Console Ports.
2. Use KVM cable sets (as described in the Cables section on page 4), to
connect any available CPU Port to the Keyboard, Video and Mouse ports
of the computer you are installing.
Note: Ignore the Daisy Chain Port at this time. It is only used when daisy
chaining additional Master View units. Daisy chaining is described
in the next section.
3. Plug the power adapter cable into the Master View's Power Jack, then plug
the power adapter into an AC power source.
4. Turn on the power to the computers.
1. Important safety information regarding the placement of this
device is provided on page iv. Please review it before
proceeding.
2. Make sure that power to all the devices you will be connecting
up have been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
acs1208-1216.book Page 9 Friday, April 27, 2007 3:23 PM