ATEN ACS1208 - Manual (Page 32)

ACS1208 / ACS1216 User Manual
20
Hotkey Beeper Control
The Beeper (see Activate Beeper, page 29) can be Hotkey toggled On and Off.
To toggle the Beeper, key in the following Hotkey combination:
1. Invoke Hotkey Mode with the [NumLock] + [*] or [NumLock] + [-]
combination
2. Press [B]
After you press B, the Beeper toggles On or Off. The Command Line displays
Beeper On or Beeper Off for one second; then the message disappears and you
automatically exit Hotkey Mode.
Hotkey Summary Table
[Num Lock] + [*] or
[Num Lock] + [-]
[Port ID] [Enter] Switches access to the computer that
corresponds to that Port ID.
[T] [n] [Enter] Sets the Auto Scan interval to n seconds -
where n is a number from 1 - 255.
[A] Invokes Auto Scan Mode.
When Auto Scan Mode is in effect, [P] or
Left Click pauses Auto Scanning.
When Auto Scanning is paused, pressing
Any Key or another Left Click resumes
Auto Scanning.
[ ←] Invokes Skip Mode and Skips from the
current port to the first accessible port
previous to it.
[ →] Invokes Skip Mode and Skips from the
current port to the next accessible port.
[ ↑] Invokes Skip Mode andSkips from the
current port to the last accessible port of
the previous Station.
[
↓]
Invokes Skip Mode andSkips from the
current port to the first accessible port of
the next Station.
[B] Toggles the Beeper On or Off.
acs1208-1216.book Page 20 Friday, April 27, 2007 3:23 PM