HP OpenView Storage Management Appliance and Software - Manual (Page 111)

Restoring the Software
95 Storage Management Appliance Software User Guide
Restoring the Software with a QuickRestore CD
You can restore the Storage Management Appliance software in one of the two
following ways:
■ Restore the SMA to Software Version 2.1 , described below
■ Restore the SMA to its Factory-Installed State , described on page 96
Restore the SMA to Software Version 2.1
HP recommends that you restore the Storage Management Appliance software to
version 2.1 using a Storage Management Appliance QuickRestore CD that
corresponds to your SMA hardware (Appliance I, II, or III). If you do not have
this CD, you can order the appropriate QuickRestore CD for your hardware
version from the following website:
http://h18006.www1.hp.com/products/sanworks/softwaredrivers/managementappliance/ .
HP recommends that you check this website periodically for the most up-to-date
QuickRestore CDs.
Note: The Storage Management Appliance I hardware (previously called SANworks
Management Appliance) did not come with a QuickRestore CD. HP recommends that
you restore to version v2.1 by using the Storage Management Appliance I QuickRestore
CD (part number 260427-B26), which you can order from:
http://h18006.www1.hp.com/products/sanworks/softwaredrivers/managementappliance/ .
After restoring the SMA with software version 2.1, follow the instructions for:
1. Reinstalling Optional Storage Management Applications , page 96
2. Reinstalling Optional Backup Software , page 97
3. Restoring the Database and Configuration Data , page 97