HP Lights-Out 100 Remote Management User Manual
Page 41
Using LO100 41
3.
Configure the network settings by entering the following:
set <network property>=<new
setting>
. Configurable valid network properties are:
o
networkaddress
specifies the IP address for the NIC. This setting is dynamic.
o
oemhp_nonvol_networkaddress
specifies the IP address stored in non-volatile memory.
o
oemhp_mask
specifies the subnet mask for NIC. This setting is dynamic.
o
oemhp_nonvol_mask
specifies the subnet mask stored in non-volatile memory.
o
oemhp_gateway specifies the gateway IP address for the NIC. This setting is dynamic.
o
oemhp_nonvol_gateway
specifies the gateway IP address stored in non-volatile memory.
o
oemhp_dhcp_enable
specifies whether DHCP is enabled for the NIC. Boolean values are
accepted
o
oemhp_nonvol_dhcp_enable
specifies whether DHCP is enabled for the NIC and address
stored in non-volatile memory.
Configuring network settings using the BIOS Setup Utility
To enable a static IP address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (
→
) key to navigate to the Advanced menu.
3.
Press the down arrow (
↓
) key to scroll to IPMI. Press the Enter key.
4.
Press the down arrow (
↓
) key to scroll to the end, and then select DHCP IP Source.
5.
Set DHCP IP Source to Disabled.
6.
Press the down arrow (
↓
) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
7.
Press the F10 key to save and exit.
To enable a DHCP assigned address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (
→
) key to navigate to the Advanced menu.
3.
Press the down arrow (
↓
) key to scroll to IPMI. Press the Enter key.
4.
Press the down arrow (
↓
) key to scroll to the end, and then select DHCP IP Source.
5.
Set DHCP IP Source to Enabled.
6.
To save and exit, press the F10 key, or to view the new IP Address, allow the server to reset and
reenter the BIOS setup utility.
To enable telnet and HTTP services:
On HP ProLiant ML110 G5 Servers, HTTP and telnet are enabled after installing the HP ProLiant Lights-Out
100c Remote Management Card.