HP XP P9500 Storage - Manual (Page 441)

The -r parameter is specified:
A new configuration definition file is created in the /kernel/drv directory.
Existing information is not inherited.
# /opt/DynamicLinkManager/bin/dlmsetconf -r
Example 4
The -u parameter is specified:
Defines a non- HDLM-managed LU based on the contents of the
definitions in the HDLM driver unconfiguration definition file (/opt/
DynamicLinkManager/config/dlmfdrv.unconf):
# /opt/DynamicLinkManager/bin/dlmsetconf -u
Note
• Execution of the dlmsetconf utility causes sd or ssd devices to be
defined in the HDLM driver configuration definition file (/kernel/drv/
dlmfdrv.conf) in units of LUs.
• Executing the dlmsetconf utility outputs the KAPL10242-I message.
Entering y in response to this message creates or updates the HDLM
driver configuration definition file (/kernel/drv/dlmfdrv.conf), the
HDLM driver unconfiguration definition file (/opt/DynamicLinkManager/
config/dlmfdrv.unconf), and the HDLM nexus driver configuration
definition file (/kernel/drv/dlmndrv.conf). Entering n in response to
this message does not create or update those files.
• When the reconfiguration option is specified to restart the host after
executing the dlmsetconf utility, HDLM deletes the HDLM-managed
logical device files for sd or ssd devices.
• The HDLM driver configuration definition file (/kernel/drv/
dlmfdrv.conf) and HDLM nexus driver configuration definition file (/
kernel/drv/dlmndrv.conf) must not be edited. Editing these
configuration definition files might result in a failure to create the correct
logical device files for HDLM devices.
• If the dlmfdrv.conf and dlmndrv.conf files exist in either the /kernel/
drv directory or in a user-defined directory, the files are renamed
dlmfdrv.conf.bak and dlmndrv.conf.bak respectively, and saved as the
previous generation of the configuration definition files. If the
dlmfdrv.unconf file exists either in the /opt/DynamicLinkManager/
config directory or in a user-defined directory, the file is renamed
dlmfdrv.unconf.bak and saved as the previous generation of the
definition file.
• Even when the -d parameter is specified, existing definition information
is read from the /kernel/drv/dlmfdrv.conf and /kernel/drv/
dlmndrv.conf files, rather than from the dlmfdrv.conf and
dlmndrv.conf files in the specified directory.
Utility Reference
7-27
Hitachi Dynamic Link Manager User Guide for Solaris ®