HP Netserver L Server series - Manual (Page 77)

Chapter 10 Configuring the NetServer
69
b. When you see the message "Press <F2> to enter SETUP" on
the monitor, press the F2 function key.
c. When the Setup Utility menu appears, use the up and down
arrow keys to highlight "Included SCSI A Channel [Yes]."
d. Use the +/- keys to change it to "Included SCSI A Channel
[No]."
e. Press the F10 function key to save and exit.
f. Answer "Yes" to the question, "Save configuration and exit
now?" The NetServer will start up again, and HP Navigator
will restart.
•
Install Utility Partition: This step creates an 8 MB utility partition on the
server hard disk where HP Navigator will copy Diagnostic Assistant, the
BIOS update utility, the event log report utility, the disk array utility, the
NIC configuration utility, the Integrated Remote Assistant utilities,
troubleshooting utilities, and other utilities. It is not available for SCO
UNIX. Select Execute on the Install Utility Partition screen.
•
Execute Board Utilities: When Configuration Assistant detects installed
boards for which there are additional configuration utilities on the HP
NetServer Navigator CD-ROM, you can execute these utilities to complete
the configuration of the boards by selecting Execute on the Execute Board
Utilities screen.
•
For Manual NOS Installation Only: Before you perform a manual NOS
installation, you must print instructions and manually create NOS-specific
drivers diskettes, as follows:
◊ Create Drivers Diskette(s): On the Create Drivers Diskette(s) screen,
select Create Drivers Diskette(s) to create one or more customized
diskettes containing HP drivers and configuration files to use when
you install the NOS.
◊ Print and Read Instructions: On the Show NOS Installation
Instructions screen, select Save to Disk to copy the Network Operating
System Installation Instructions to disk. Then print them out from the
disk. Read the instructions first, and then follow them to manually
install the NOS.