HP EliteBook 2740p Tablet-PC - Manual (Page 154)

15 MultiBoot
About the boot device order
As the computer starts, the system attempts to boot from enabled boot devices. The MultiBoot utility,
which is enabled at the factory, controls the order in which the system selects a boot device. Boot
devices can include optical drives, diskette drives, a network interface card (NIC), hard drives, and
USB devices. Boot devices contain bootable media or files that the computer needs to start and
operate properly.
NOTE: Some boot devices must be enabled in Computer Setup before they can be included in the
boot order.
The factory setting is for the computer to select the boot device by searching enabled boot devices
and drive bay locations in the following order:
NOTE: Some of the boot devices and drive bay locations listed may not be supported on your
computer.
● Notebook MultiBay
● Internal hard drive
● USB diskette drive
● USB CD-ROM
● USB hard drive
● Notebook Ethernet
● Secure Digital (SD) Memory Card
● Docking station MultiBay
● External SATA drive
You can change the order in which the computer searches for a boot device by changing the boot
order in Computer Setup. You can also press
esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen, and then press f9 . Pressing f9 displays a menu
that shows the current boot devices and allows you to select a boot device. Or, you can use MultiBoot
Express to set the computer to prompt you for a boot location each time the computer turns on or
restarts.
If MultiBoot is disabled, the computer uses a fixed boot order that consists of first searching for a
drive A boot device. If none is found, the computer looks for a drive C boot device. Drive A boot
devices include optical drives and diskette drives. Drive C boot devices include optical drives and
hard drives.
142 Chapter 15 MultiBoot