HP DesignJet 500 - Manual (Page 159)

Media & Ink Introduction Front-Panel Other Index Solutions
The Front-Panel Setup Menus Consumable Menus Internal Prints Navigation
Message
Descriptions
Printer
Options
Media mispositioned.
1_ Lift lever
2_ Correct position
3_ Lower lever The roll is mis-positioned in
the printer. This may mean
the media is too far to the
left on the platen For guidelines on loading
media see
Loading Roll Media
Guidelines
Media too small The media you are
attempting to load is too
small for the printer to use. For the minimum size of media
the printer can use see
Functional Specifications
Misalignment This means that the media
has not been fed into the
printer straight. Reload the media making sure
that the edges of the media
are parallel and that it is
straight when you feed it in.
Align the media coming out
from the printer with the media
going into the printer, see
Loading Roll Media
Misposition The media is not positioned
correctly in the printer. The
media may be too far to the
left or the right. Check you have loaded the
media correctly as shown in
the procedure
Loading Roll
Media
No media profile
available. Unload roll. The media you are
attempting to load does not
have a media profile
associated with it, so the
printer does not know how
to print on it. See Media Profile
Downloading for details of the
down loading media profiles
procedure. If this is not
successful, switch the printer
On and then Off again.
Status Description Procedure