Atlantis Land A02-IPCAM4-W54 - Manual (Page 51)

NetCamera NVW
A02-IPCAM4-W54 52
4.2.4 Breach Manager
The Breach Manager submenu enables you to configure all breach alert and motion
detection settings:
You can configure the system to capture images when either the motion sensors, DI1
or DI2 sensors are activated.
To set a breach alert, do the following:
Select the alert trigger device type by checking the Enable checkboxes next to each
device.
Select the notification method from the list of options:
• Send e-mail: The system will send you an email when the device is
triggered.
• Send images to FTP server : The system will send captured images to
the FTP server when the device is triggered.
• Trigger GPIO output : The system will send a signal to the alarm devices.