HP Integrated Lights-Out 4 - Manual (Page 29)

Configuring Automatic Group Power Capping settings
1. Navigate to the iLO Federation
→Group Power Settings page, as shown in
Figure 8 (page
29) .
Figure 8 Group Power Settings page
2. Select a group from the Selected Group menu.
All of the systems in the selected group will be affected by the changes you make on this page.
3. Select the Enable power capping check box.
4. Enter the Power Cap Value in watts, BTU/hr, or as a percentage.
The percentage is the difference between the maximum and minimum power values. The
power cap value cannot be set below the server minimum power value.
When values are displayed in watts, click Show values in BTU/hr to change the display to
BTU/hr. When values are displayed in BTU/hr, click Show values in Watts to change the
display to watts.
5. Click Apply.
Using the iLO Federation firmware update feature
The Group Firmware Update feature enables you to update the firmware of multiple servers from
a system running the iLO web interface.
A license is required if you want to make changes on the Group Firmware Update page. For more
information about iLO licensing, see the following website:
http://www.hp.com/go/ilo/licensing .
This feature allows you to do the following:
•
View the number of servers with each supported firmware version. The percentage of the total
number of servers with the listed firmware version is also displayed.
•
View the flash status for the grouped servers. The percentage of the total number of servers
with the listed flash status is also displayed.
•
View the TPM status for the grouped servers in the Option ROM Measuring section. The
percentage of the total number of servers with the listed TPM status is also displayed.
•
Update the firmware. The following firmware types are supported:
iLO ◦
◦ HP ProLiant System ROM
Using the iLO Federation firmware update feature 29