HP Jetdirect 280m 802.11b Wireless Print Server - Manual (Page 108)

HP Jetdirect troubleshooting
Reconfigure your printer.
You need to reconfigure your wireless printer. Take the following steps:
1. Reset the print server to its factory default configuration. ( Click
here for instructions. )
2. Run the Wireless Setup Wizard and the Install Network Printer
Wizard. To start the Wireless Setup Wizard, insert the HP Jetdirect CD
into your computer. When the main screen comes up, select "Install"; then
select "Wireless"; then select "No, the wireless settings have not been
configured . . ."; then select "Step 1 -- Configure printer's wireless settings".
After running the Wizards, is the Status light still green, blinking
slowly?
If yes, the troubleshooting procedure has gone as far as it can go. You will need
further assistance from HP technical support. Click on Yes for information about
contacting HP technical support.
If the blink pattern of the Status light has changed, click on No to return to the
start of the troubleshooting procedure and evaluate the state of the Status light.
file:///C|/Bottlecap_Structure_26--TestMerge/DOCS/EN/280M/USER/LWTNR05.HTM [5/20/2003 3:59:59 PM]