HP Neoview Release 2.5 Software - Manual (Page 68)

resubmitting it, and you want Transporter to perform recovery on the job. For more information
about -recover, refer to
“ The -recover Command Line Option” (page 80) .
Starting the Client on UNIX-type Systems
Use this shell command to start the Transporter Client. You specify the control file depending
on where the file resides. If the control file is not found, Transporter exits with an error.
• The control file is in NVTHOME/conf:
jtrans.sh {-run | -recover} MyControlFile.txt
• The control file is in the current directory:
jtrans.sh {-run | -recover} ./MyControlFile.txt
• The control file is in a directory you specify — in this case, /my/trans/dir:
jtrans.sh {-run | -recover} /my/trans/dir/MyControlFile.txt
Starting the Client on Windows Systems
Type this at the “Command prompt on a Windows system” to start the Transporter Client. You
specify the control file depending on where the file resides. If the control file is not found,
Transporter exits with an error.
• The control file is in %NVTHOME%\conf. This is the default.
jtrans.bat {-run | -recover} MyControlFile.txt
• The control file is in the current directory:
jtrans.bat {-run | -recover} .\MyControlFile.txt
• The control file is in a directory you specify — in this case, d:\my\trans\dir:
jtrans.bat {-run | -recover} d:\my\trans\dir\MyControlFile.txt
Command prompt on a Windows system
1. Click Start –> Run
2. In the Open text box, type cmd.exe
Displaying the Installed Version of Transporter
To obtain the currently installed version of Transporter, use this command:
jtrans -version
Stopping the Client
The Transporter client stops automatically when a data movement operation directed by a control
file has completed or if the job fails. You can recover a failed operation later, unless the job to
recover involves one of these:
• An extract operation
• A load operation using a staging table
• A load operation with the “noaudit” (page 61)
option set to true.
• A load operation with the “autotran” (page 53)
option set to true.
• A load operation using a named pipe or JMS trickle feed source.
For more information about job recovery, refer to “Job Recovery” (page 80) .
68 Load and Extract Operations